IEMCA KID 80 - Remnant Handling

2 - INFORMATION FOR USE KID 80 SIV
EN
2 - Pag. 33 / 66
no. 21 Remnant handling
1 - (Ejection)
2 - (Bar change advance no first feeding)
3 - (Bar change advance no facing)
Mode 1 - (Ejection) or 2 - (Bar
change advance)
Foreword
To enable one of the two modes, the
lathe should have a subprogramming
function.
The subprogram should control the bar
stop removal at the bar end signal.
The bar stop removal allows the ejection
of the remnant from side (A) of the lathe.
21
no. 21 Remnant
handling
xxxxxxxxxx
DEFAULT VALUE
PROGRAMMABLE
VALUE
KID KID
0 0/1/2/3