IEMCA KID 80 - Exiting the Parameters; Operator Parameters: Description

2 - INFORMATION FOR USE KID 80 SIV
EN
2 - Pag. 17 / 66
4. Enter the desired value, for example "1200": the value changes from 1100 to 1200 and
starts blinking, confirm:
The value stops blinking:
If during the modification mode you want to stop
the selection:
At this stage the value is no longer blinking. If
the value is not confirmed when entered, the last
value will reappear.
2.10 EXITING THE PARAMETERS
1. Exit the "parameter display" mode: [pupa_kid_barra_vert-dx]
2.11 OPERATOR PARAMETERS: DESCRIPTION
--------------------------
New speed
1000 (mm/sec)
--------------------------
Con. acceleration
1200 (mm/sec*sec)
--------------------------
New speed point
--------------------------
New speed
1000 (mm/sec)
--------------------------
Con. acceleration
1100 (mm/sec*sec)
--------------------------
New speed point