IEMCA KID 80 - 0-Axis Procedure (Manual Mode)

EN
2 - INFORMATION FOR USE KID 80 SIV
2 - Pag. 4 / 66
2.2 0-AXIS PROCEDURE (MANUAL MODE)
List of causes requiring the 0-Axis in manual mode:
- carrying out the manual 0-Axis periodically is recommended;
- if the bar pusher axis is moved by means of the crank or the lathe headstock is moved
with the bar feeder powered off (no power supply).
- if the feeding belt is tightened (by means of the mechanical chain tightener, see
Operation and Maintenance Manual, "Feeding chain - Adjustment").