IEMCA KID 80 - Bar Feeder Stop

EN
2 - INFORMATION FOR USE KID 80 SIV
2 - Pag. 8 / 66
2.4 BAR FEEDER STOP
Bar feeder stop in emergency.
1. Press the emergency button to stop the bar feeder.
WARNING - CAUTION
If the emergency stop is activated whilst the lathe is working, before restarting
the working cycle, check that no dangerous conditions have been created due to
the sudden stop. For example: if the tool was removing chips, move the tool
away from the work piece before restarting the lathe.
Stopping the bar feeder at the end of the machining cycle.
WARNING - CAUTION
When stopping the machine normally, do not use the emergency buttons.
1. Complete the operations of your working schedule.
2. Stop the bar feeder:
3. Stop the lathe.
4. Turn off the electrical supply of the bar feeder by turning the main switch to the 0 (OFF)
position.