IEMCA KID 80 - Collet Entry Slowdown

EN
2 - INFORMATION FOR USE KID 80 SIV
2 - Pag. 26 / 66
no. 11 Collet entry slowdown
Defines the length of the slowdown section
from (F) to (G). Along this section the bar
moves at the collet entry speed (see
parameter 12).
F = collet entry slowdown start referred to (C);
G = see subparameter (N) of Parameter 14;
C = Collet outer alignment Parameter 64;
I = Facing (Parameter 64 + Parameter 2), in the
example in the picture the hypothetical value
entered in Parameter 2 = 100 mm. The value can
be either positive or negative, for further
information see Parameter 2.
11
no. 11 Collet entry
slowdown
XXXXX (mm)
(inches)
DEFAULT VALUE
PROGRAMMABLE
VALUE
KID KID
200 /