IEMCA KID 80 - Piece Timeout; Bar Feeding Handling

2 - INFORMATION FOR USE KID 80 SIV
EN
2 - Pag. 37 / 66
no. 23 Piece timeout
This is the maximum duration of the piece
machining.
If for any reason the period for machining
of a piece exceeds the set time, the bar
feeder will activate the "ALARM".
no. 25 Bar feeding handling
0 - (FEEDING END WITH BAR CHANGE):
the bar feeder will stop feeding when the
BAR CHANGE signal is received.
1 - (FEEDING END WITH K1): in the
presence of the BAR END (K1) signal, the
bar feeder stops the feeding.
23
no. 23 Piece timeout
xxxx (sec)
DEFAULT VALUE
PROGRAMMABLE
VALUE
KID KID
0 0
25
no. 25 Bar feeding
handling
xxxxxxxxxx
DEFAULT VALUE
PROGRAMMABLE
VALUE
KID KID
0 0