EN
2 - INFORMATION FOR USE KID 80 SIV
2 - Pag. 2 / 66
2.1 AUTOMATIC CYCLE START
1. Power on the lathe.
2. Power on the bar feeder by turning the main switch to position I (ON)
.
The hourglass appearing on the display shows the synchronization of data among
electronic components.
DANGER - WARNING:
it is absolutely forbidden to move the bar
pusher before the above-mentioned
procedure has been completed. The bar
pusher can be moved only after pressing the
start button (see point 3 Starting the bar
feeder). For example: when starting the bar
feeder, the +Z -Z axis of the lathe
headstock is moved with the collet closed.
This manoeuvre can cause serious damages
to the bar feeder and the lathe.
3. Select the manual mode:
4. Select the "BAR FEEDER ZERO SETTING" of the carriage:
and
If the top guide channels are not in a low position, the carriage will not move; to lower the
guide channels, follow the operational messages which will appear on the screen.
Follow instructions given above and reset the carriage to "BAR FEEDER ZERO SETTING":
5. Bring the bar fore end close to the cutting tool:
To Next Page
Loading...
