IEMCA KID 80 - Piece Length

EN
2 - INFORMATION FOR USE KID 80 SIV
2 - Pag. 24 / 66
no.6 Piece length
Defines the feeding value at each collet
opening.
This parameter is active only if parameter
35 is set to "1" or "2".
When parameter 35 is set to "0", this
parameter is not active.
A parameter 6
B about 4 mm
no. 7 Open collet speed
Defines the "FEEDING" speed value.
6
no.6 Piece
length
xxxx (mm)
(inches)
DEFAULT VALUE
PROGRAMMABLE
VALUE
KID KID
0 0
7
no. 7 Open collet
speed
xxxxx (mm/sec)
DEFAULT VALUE
PROGRAMMABLE
VALUE
KID KID
300 0[diviso]1905