IEMCA KID 80 - Piece Counter Reset Mode

1 - BASE INFORMATION KID 80 SIV
EN
1 - Pag. 15 / 15
1.4 PIECE COUNTER RESET MODE
1. Enter the "parameter display" mode: [pupa_kid_barra_oriz-sx]
2. the display shows:
to access "Common Parameters":
3. Press
and scroll the parameters up to "Total
pieces"
4. Select the residual value: the display shows:
5. Eliminate the residual value:
confirm:
The selected residual value: Total pieces 50
if you wish to stop the selection during the zero
setting mode
At this stage the value is no longer blinking. If the reset has not been confirmed, the
previous residual value will reappear.
(EN)
Help
Machining
Parameters
Common parameters
Long feed. safety
0.000 (mm)
Max. feed. pos. adj.
0.000 (mm)
0.00 (inches)
Total pieces
50