IEMCA KID 80 - Main Screens Description

EN
1 - BASE INFORMATION KID 80 SIV
1 - Pag. 10 / 15
1.3 MAIN SCREENS: DESCRIPTION
These are the main screens:
- operation
- setup
The working screen shows the bar feeder working conditions.
The Setup screen shows the setting functions.
1.3.1 Working screen
1. When the bar feeder is on, the following screen is displayed:
Bar feeder operating mode: MANUAL MODE.
Quantity of machinable pieces of the bar being
machined.
Carriage position: Position from '0'.
"K1" is displayed when the bar feeder is at the bar
end. In all the other operating conditions it is not
displayed.
2. To continue with the screen display, repeatedly
press:
the display shows:
Carriage position: Position from "F"
Quantity of machined pieces (for zero setting mode
see section 1.4): Total pieces
3. To return to the main screen repeatedly press:
MANUAL MODE
--------------------
Machinable pieces
100
Position from '0, K1
3.34 (mm)
0.13 (inches)
Position from "F"
144.66 (mm)
5.69 (inches)
Total pieces
50