IEMCA KID 80 - Page 35

2 - INFORMATION FOR USE KID 80 SIV
EN
2 - Pag. 13 / 66
6. Recall the "Main Menu": the display shows
7. To return to the short menu press [pupa_kid_barra_vert-dx] and proceed as described in
section 2.6.1.
8. To directly access the parameters return to screen 4. and proceed as follows:
9. Recall the selection cursor
. The Par.0 value
starts blinking.
10. Enter the parameter number, for example "1";
the parameter value changes from 0 to 1 and
starts blinking; confirm:
parameter 1 is now displayed
(EN)
Help
Machining
Parameters
Common parameters
Bar feeder waiting
MANUAL MODE
--------------------
Position from '0, K1
3.34 (mm)
0.13 (inches)
--------------------
PARAMETERS
-----------------------
Par.
IEMCA Parameters
Param. Operator