Parameter Groups
‑147‑
0: No function
1: Forward run (FWD)
2: Reverse run (REV)
3: Three‑wire control
4: Forward jog (FJOG)
5: Reverse jog (RJOG)
6:Terminal (UP)
7:Terminal (DOWN)
8: Coast to stop
9: Fault reset (RESET)
10: Running pause
11: NO input of external fault
12: Multi‑reference terminal 1
13: Multi‑reference terminal 2
14: Multi‑reference terminal 3
15: Multi‑reference terminal 4
16: Terminal 1 for acceleration/deceleration selection
17: Terminal 2 for acceleration/deceleration selection
18: Frequency source switchover
19: UP and DOWN setting clear (terminal, operating panel)
20: Command source switchover terminal
21: Acceleration/Deceleration inhibited
22: PID pause
23: PLC state reset
24: Wobble pause
25: Counter input (DI5)
26: Counter reset
27: Length count input (DI5)
28: Length reset
29: Torque control inhibited
30: Pulse input
31: Reserved
32: Immediate DC braking
33: NC input of external fault
34: Frequency modification enabled
35: PID action direction reversal
To Next Page
Loading...
