Inovance MD500-PLUS Series - Page 214

Parameter Groups
‑213‑
Max.: 100 Data type: UInt16
Default:
100
Change:
At stop
Value Range:
0% to 100%
Description
Indicates the braking usage rate.
F6-16
Closed loop current Kp of flying start
Address:
0xF610
Min.:
0
Unit:
‑
Max.: 1000 Data type: UInt16
Default:
500
Change: In real time
Value Range:
0–1000
Description
This parameter defines the proportional gain of the current suppression PI
regulator during speed tracking of flying start. It is valid when F6‑01 is set to 0, 1,
or 2.
F6-17
Closed-loop current Ki of torque tracking
Address:
0xF611
Min.:
0
Unit:
‑
Max.: 1000 Data type: UInt16
Default:
800
Change: In real time
Value Range:
0–1000
Description
This parameter defines the integral gain of the current suppression PI regulator
during speed tracking of flying start. It is valid when F6‑01 is set to 0, 1, or 2.
F6-18
Flying start current
Address:
0xF612
Min.:
30
Unit:
‑
Max.: 200 Data type: UInt16
Default:
100
Change: In real time
Value Range:
30 to 200
Description
Overcurrent may occur on the asynchronous motor during flying start due to large
slip. The current must be limited for preventing overcurrent. This parameter
defines the motor current to be suppressed during speed tracking of flying start.