Inovance MD500-PLUS Series - Page 229

Parameter Groups
‑228‑
Description
0: Run at frequency lower limit
If the frequency reference is lower than the frequency lower limit, the AC drive
runs at the frequency lower limit.
1: Stop according to F6‑10
If the frequency reference is lower than the frequency lower limit, the AC drive
stops in the mode set by F6‑10.
2: Run at zero speed
If the frequency reference is lower than the frequency lower limit, the AC drive
runs at zero speed.
3: Coast to stop
If the frequency reference is lower than the frequency lower limit, the AC drive
coasts to stop.
F8-15
Mechanical braking frequency
Address:
0xF80F
Min.:
0
Unit:
Hz
Max.: 10 Data type: UInt16
Default:
0
Change: In real time
Value Range:
0.00 Hz to 10.00Hz
Description
F8-16
Accumulative power-on time threshold
Address:
0xF810
Min.:
0
Unit:
h
Max.: 65000 Data type: UInt16
Default:
0
Change: In real time
Value Range:
0–65000 h
Description
This parameter is used to set the accumulative power‑on time threshold of the AC
drive. When F7‑13 (Accumulative power‑on time threshold) exceeds F8‑16
(Accumulative power‑on time threshold), the DO outputs an active signal.
F8-17
Accumulative running time threshold
Address:
0xF811
Min.:
0
Unit:
h
Max.: 65000 Data type: UInt16
Default:
0
Change: In real time