Inovance MD500-PLUS Series - Page 386

Parameter Groups
‑385‑
Description
When analog voltage correction is conducted on AI3, a correction curve is
obtained based on two points. Each point corresponds to a measured voltage and
a displayed voltage. The measured voltage is the voltage measured using a meter,
and the displayed voltage is the AI3 voltage before correction (U0‑23).
AC-09
AI3 displayed voltage 1
Address:
0xAC09
Min.:
‑10
Unit:
V
Max.: 10 Data type: Int16
Default:
2
Change: In real time
Value Range:
‑10.000 V to +10.000 V
Description
When analog voltage correction is conducted on AI3, a correction curve is
obtained based on two points. Each point corresponds to a measured voltage and
a displayed voltage. The measured voltage is the voltage measured using a meter,
and the displayed voltage is the AI3 voltage before correction (U0‑23).
AC-10
AI3 measured voltage 2
Address:
0xAC0A
Min.:
‑10
Unit:
V
Max.: 10 Data type: Int16
Default:
8
Change: In real time
Value Range:
‑10.000 V to +10.000 V
Description
When analog voltage correction is conducted on AI3, a correction curve is
obtained based on two points. Each point corresponds to a measured voltage and
a displayed voltage. The measured voltage is the voltage measured using a meter,
and the displayed voltage is the AI3 voltage before correction (U0‑23).
AC-11
AI3 displayed voltage 2
Address:
0xAC0B
Min.:
‑10
Unit:
V
Max.: 10 Data type: Int16
Default:
8
Change: In real time
Value Range:
‑10.000 V to +10.000 V