Inovance MD500-PLUS Series - Page 387

Parameter Groups
‑386‑
Description
When analog voltage correction is conducted on AI3, a correction curve is
obtained based on two points. Each point corresponds to a measured voltage and
a displayed voltage. The measured voltage is the voltage measured using a meter,
and the displayed voltage is the AI3 voltage before correction (U0‑23).
AC-12
AO1 measured voltage 1
Address:
0xAC0C
Min.:
‑10
Unit:
V
Max.: 10 Data type: Int16
Default:
2
Change: In real time
Value Range:
‑10.000 V to +10.000 V
Description
When analog voltage correction is carried out on the AO1 terminal, a correction
curve is formed through two points. Each point corresponds to a target voltage
and a measured voltage. The target voltage is the expected output voltage, and
the measured voltage is the output voltage actually measured.
AC-13
AO1 target voltage 1
Address:
0xAC0D
Min.:
‑10
Unit:
V
Max.: 10 Data type: Int16
Default:
2
Change: In real time
Value Range:
‑10.000 V to +10.000 V
Description
When analog voltage correction is carried out on the AO1 terminal, a correction
curve is formed through two points. Each point corresponds to a target voltage
and a measured voltage. The target voltage is the expected output voltage, and
the measured voltage is the output voltage actually measured.
AC-14
AO1 measured voltage 2
Address:
0xAC0E
Min.:
‑10
Unit:
V
Max.: 10 Data type: Int16
Default:
8
Change: In real time
Value Range:
‑10.000 V to +10.000 V