Inovance MD500-PLUS Series - Page 414

Parameter Groups
‑413‑
B0-09
Reel diameter
Address:
0xB009
Min.:
0.1
Unit:
mm
Max.: 6000 Data type: UInt16
Default:
100
Change: In real time
Value Range:
0.1 mm to 6000.0 mm
Description
Actual reel diameter
B0-10
Initial roll diameter source
Address:
0xB00A
Min.:
0
Unit:
‑
Max.: 4 Data type: UInt16
Default:
0
Change:
At stop
Value Range:
0: B0‑11 to B0‑13 setting
1: AI1 setting
2: AI2 setting
3: AI3 setting
4: Communication setting (1000H)
Description
This parameter is used to select the input channel of the initial roll diameter. The
source of initial roll diameter is dependent on functions 55 and 56 (initial roll
diameter selection terminal) of the DI and related to the winding mode.
0: B0‑11 to B0‑13
By default, the initial roll diameter source is determined to be B0‑08 or B0‑09
based on the winding mode.
1 to 4: The initial roll diameter can be obtained through channels 1 to 4. When
using the preceding channels, the maximum roll diameter (B0‑08) must be set
correctly according to the per unit relationship.
B0-11
Initial roll diameter 1
Address:
0xB00B
Min.:
0.1
Unit:
mm
Max.: 6000 Data type: UInt16
Default:
100
Change: In real time
Value Range:
0.1 mm to 6000.0 mm
Description
For details about initial roll diameters 1 to 3, see B0‑10.