Inovance MD500-PLUS Series - Page 421

Parameter Groups
‑420‑
1 to 10000
Description
This parameter specifies the number of revolutions for each layer of winded
materials, generally used for wire rods. For wire rods, set B0‑30 to 1.
B0-31
Material thickness reference source
Address:
0xB01F
Min.:
0
Unit:
‑
Max.: 3 Data type: UInt16
Default:
0
Change:
At stop
Value Range:
0: Digital setting
1: AI1
2: AI2
3: AI3
Description
You can set B0‑31 to select an input channel of material thickness.
0: Digital setting
The material thickness is affected by the DI functions 62 and 63 (material
thickness selection terminal).
1 to 3: The initial roll diameter can be obtained through channels 1 to 3. When the
preceding channels are used, the maximum material thickness (B0‑36) must be
set correctly based on the per‑unit relationship.
B0-32
Material thickness 0
Address:
0xB020
Min.:
0.01
Unit:
mm
Max.: 100 Data type: UInt16
Default:
0.01
Change: In real time
Value Range:
0.01 mm to 100.00 mm
Description
For details about the material thickness 0 to 3, see B0‑31.
B0-33
Material thickness 1
Address:
0xB021
Min.:
0.01
Unit:
mm
Max.: 100 Data type: UInt16
Default:
0.01
Change: In real time
Value Range:
0.01 mm to 100.00 mm