Parameter List
‑89‑
Parameter Name Basic Unit Communication
Address
U0‑27 Pulse input reference (Hz) 1Hz 0x701B
U0‑28 Communication 0.01% 0x701C
U0‑29 Encoder feedback speed (Hz) 0.01 Hz 0x701D
U0‑30 Display of main frequency X 0.01 Hz 0x701E
U0‑31 Display of auxiliary frequency Y 0.01 Hz 0x701F
U0‑32 Any memory address 1 0x7020
U0‑33 Synchronous motor rotor position 0.1° 0x7021
U0‑34 Motor temperature 1℃ 0x7022
U0‑35 Target torque (%) 0.1% 0x7023
U0‑36 Resolver position 1 0x7024
U0‑37 Power factor angle 0.1° 0x7025
U0‑38 ABZ position 1 0x7026
U0‑39 Target voltage upon V/f separation 1 V 0x7027
U0‑40 Output voltage upon V/f separation 1 V 0x7028
U0‑41 DI state display 1 0x7029
U0‑42 DO state display 1 0x702A
U0‑43 DI function state display 1 (function 01 to
40)
1 0x702B
U0‑44 DI function state display 2 (functions 41 to
80)
1 0x702C
U0‑45 Fault information 1 0x702D
U0‑46 Inverter unit temperature 1℃ 0x702E
U0‑47 PTC channel voltage before correction 0.001 V 0x702F
U0‑48 PTC channel voltage after correction 0.001 V 0x7030
U0‑49 Number of offset pulses of position lock 1 0x7031
U0‑50 Roll diameter 1 mm 0x7032
U0‑51 Tension (after taper setting) 1 N 0x7033
U0‑58 Z signal counting 1 0x7034
U0‑59 Frequency reference (%) 0.01% 0x7035
U0‑60 Running frequency (%) 0.01% 0x7036
U0‑61 AC drive state 1 0x7037
U0‑62 Current fault code 1 0x7038
U0‑63 Running frequency (after droop) 0.01 Hz 0x7039
U0‑64 Back EMF 0.1 V 0x703A
U0‑65 Stator resistance auto‑tuning upon startup 1 0x703B
U0‑66 Communication extension card model 1 0x703C
U0‑67 Software version of the communication
extension card
1 0x703D
U0‑68 AC drive state on the communication
extension card
1 0x703E
U0‑69 Frequency transmitted to the
communication extension card/0.01 Hz
1 0x703F
To Next Page
Loading...
