Intel® Server Board S2600CW Connector/Header Locations and Pin-outs
Intel® Server Board S2600CW Family TPS
110 Revision 2.4
• Reuse Pin A7 as SAS_MODULE_ENABLE. This change applies to standard PCIe slot as
well
• Reuse Pin B17 as MUX_RST_N.
• Reuse Pin B48/A50/B31 as LINK_WIDTH_ID.
• Reuse A32/A33 as additional PCIe Clocks to the 2nd slot on the risers.
NOTES:
The 3rd REFCLK is not used.
LINK_WIDTH_ID2 is not used on slot 6, which is pulled to GND via a 4.75Kohm resistor.
For pin B12, it is connected to system throttling signal to throttle input for Xeon Phi.
To Next Page
Loading...
