Intel Stratix 10 Configuration User Guide

5.1.2. Remote System Upgrade Configuration Images
Intel Stratix 10 devices using remote system upgrade require the following
configuration images:
• A Factory image—contains logic with enough functionality to implement the
following functions:
— Your design-specific logic to obtain new application images
— Your design-specific logic to request reconfiguration using a specific application
image
— Image storage in flash memory
• Application image—contains logic to implement the custom application. The
application image must also contain logic to obtain new application images and
store the images in the flash memory.
Note: The application image is optional. You can create a remote system upgrade
image containing the factory image only. The application image can be
added or obtained after you configure the device with the factory image.
Depending on the storage space of your flash memory, Intel Stratix 10 remote system
upgrade supports one factory application image and up to 507 application images. The
Quartus Programming File Generator only supports up to three remote system
upgrade images. However, you can add new additional images using the Serial Flash
Mailbox Client IP with the device in user mode.
5. Remote System Upgrade
UG-S10CONFIG | 2018.11.02
Send Feedback
Intel Stratix 10 Configuration User Guide
75

Intel Stratix 10 Specifications

General

Brand	Intel
Model	Stratix 10
Category	Control Unit
Language	English