Intel Stratix 10 Configuration User Guide

5.
Select the .pof to be programmed to the selected device.
6. When available, you can enable the real-time ISP mode by turn-on the Enable
real-time ISP to allow background programming.
7. Click Start to start programming.
3.2.8.3. Programming .jic files into Serial Flash Device
To program the .jic into the serial flash device through the JTAG interface, perform
the following steps:
1. In the Programmer window, click Hardware Setup and select the desired
download cable.
2. In the Mode list, select JTAG.
3. Select the device to be programmed and click Add File.
4.
Select the .jic to be programmed to the selected device.
5. Click Start to start programming.
3.2.9. Debugging Guidelines for the AS Configuration Scheme
The AS configuration scheme operation is like earlier device families. However, there is
one significant difference. Intel Stratix 10 devices using AS mode, try to load a
firmware section from addresses 0, 256k, 512k and 768k in the serial flash device
connected to the CS0 pin. The firmware section is static for a particular Intel Quartus
Prime Pro Edition release.
The firmware includes a pointer to the configuration bitstream design sections. If the
configuration bitstream does not include a valid image, the SDM asserts an error by
driving nSTATUS low. You can recover from the error by reconfiguring the FPGA over
JTAG, or by driving nCONFIG low.
SDM tristates AS pins, AS_CLK, AS_DATA0-AS_DATA3, and AS_CS0-AS_CS3, only
when the device powers on if you set MSEL to JTAG. If MSEL is either AS fast or
normal, the SDM drives the AS pins until you power cycle the Intel Stratix 10 device.
Unlike earlier device families, the AS pins are not tristated when the device enters
user mode.
The AS configuration scheme has power-on requirements. If you use AS Fast mode
and are not concerned about 100 ms PCIe link training requirement, you must still
ramp the V
CCIO_SDM
supply within 18 ms. This ramp-up requirement ensures that the
AS x4 device is within its operating voltage range when the Intel Stratix 10 device
begins assessing the AS x4 device.
When using AS fast mode, all power supplies to the Intel Stratix 10 device must be
fully ramped-up to the recommended operating conditions within 10 ms. To meet the
PCIe 100 ms power-up-to-active time requirement for CvP, the V
CCIO_SDM
power to the
Intel Stratix 10 device must be at the recommended operating range within 10 ms.
3. Intel Stratix 10 Configuration Schemes
UG-S10CONFIG | 2018.11.02
Send Feedback
Intel Stratix 10 Configuration User Guide
61

Intel Stratix 10 Specifications

General

Brand	Intel
Model	Stratix 10
Category	Control Unit
Language	English