Attachments
Quickhitch
Figure 79.
A Front pivot pin
Hydraulic Hitch Unlock Sequence
Standard Attachment
1. To start Quickhitch unlock process make sure that hydraulics are on then press the Quickhitch sequence
switch.
Figure 80.
2. Press the control isolation switch to confirm the process. Make sure that LED (Light Emitting Diode) on
the boom turns red.
Figure 81.
3. To disengage the pivot pin, crowd the attachment for the specified time then remove the attachment.
Duration: 3s
Figure 82.
4. Operate the machine to engage the jaw with the new attachment and then full crowd the attachment to
align latch.
93 9831/8250-4 93
JCB © Admin Pimteam - 23/06/2021 05:32.
To Next Page
Loading...
