Attachments
Quickhitch
Figure 77.
F Latch hook locking pin G Lynch pin
H Tommy bar
4. Insert the tommy bar into the hole of the latch hook as shown.
WARNING! The attachment will move when released. Stand clear and to one side when releasing the
attachment.
5. Apply a downward pressure on the tommy bar to release the attachment rear pivot pin from the Quickhitch
as shown. Refer to Figure 78.
Figure 78.
D Rear Pivot pin H Tommy bar
6. Start the engine, rest attachment on the ground and engage the hydraulics
7. Slowly roll the Quickhitch and raise the excavator arm to release the attachment front pivot pin from the
front jaw of the Quickhitch as shown. Refer to Figure 79.
92 9831/8250-4 92
JCB © Admin Pimteam - 23/06/2021 05:32.
To Next Page
Loading...
