Johnson Controls York YCIV A Series - One Inch Deflection Spring Isolators Cross-Reference

JOHNSON CONTROLS
162
FORM 201.23-NM2
ISSUE DATE: 3/9/2015
SECTION 6 - TECHNICAL DATA
ONE INCH DEFLECTION SPRING ISOLATORS CROSS-REFERENCE
RATED CAPACITY (For units with all load points less
than 1785 lbs (810kg)
VENDOR P/N COLOR YORK P/N
*lbs *kg
Up to 434 Up to 197 CP-1D-510 BLACK 029-25334-002
435 through 765 198 through 347 CP-1D-900 DK GREEN 029-25334-003
766 through 1020 348 through 463 CP-1D-1200 GRAY 029-25334-004
1021 through 1156 464 through 524 CP-1D-1360 WHITE 029-25334-005
1157 through 1785 525 through 810 CP-1D-1785N GRAY/RED 029-25334-006
Up through 1148 Up through 521 C2P-1D-1350 DK PURPLE 029-25334-008
1149 through 1530 522 through 694 C2P-1D-1800 DK GREEN 029-25334-009
1531 through 2040 695 through 925 C2P-1D-2400 GRAY 029-25334-010
2041 through 2312 926 through 1049 C2P-1D-2720 WHITE 029-25334-012
2313 through 3570 1050 through 1619 C2P-1D-3570N GRAY/RED 029-25334-013
* Value is de-rated by 15%
NOTE: Isolators with 1” deection (Pin 54 = 1) must be of the same class for the entire unit. IE. Must use C2P’s at all locations on a selected
unit, or all CP’s
LD13759
W"
D"
L"
B"
C"
H"
T"
Ø1/2"
5/8"
NOTES:
1. ALL DIMENSIONS ARE IN INCHES, INTERPRET PER ANSI Y14.
2. STANDARD FINISH: HOUSING-POWDER COATED, SPRING-POWDER COATED (COLOR: SEE TABLE),
HARDWARE-ZINC-ELECTROPLATE.
3. INSTALLATION REQUIRES BOLTING OR ANCHORING MOUNT TO SUPPORT STRUCTURE WITH A MIN (2)
5/8" DIA BOLT OR (2) 1/2" DIA CONCRETE ANCHORS.
4. ALL SPRINGS ARE DESIGNED FOR 50% OVER-TRAVEL.
5. REFER TO PAGE FOR INSTALLATION INSTRUCTIONS.
MODEL
NUMBER
RATED
CAPACITY
(LBS.)
RATED
DEFLECTION
(IN)
COLOR CODE
JCI PART
NUMBER
C2P-1D-1020 1020 1.02 BLACK
C2P-1D-1350 1350 1.32 DK. PURPLE
029 25334 008
029 25334 007
C2P-1D-1800 1800 1.02 DK. GREEN 029 25334 009
C2P-1D-2400 2400 0.9 GRAY
029 25334 010
029 25334 011
C2P-1D-2720 2720 0.77 WHITE 029 25334 012
C2P-1D-3570N 3570 0.88 GRAY / RED 029 25334 013
MODEL
NUMBER
RATED
CAPACITY
(LBS.)
RATED
DEFLECTION
(IN)
COLOR CODE
JCI PART
NUMBER
CP-1D-85 85 1.36 LT. PURPLE
CP-1D-120 120 1.2 DK. YELLOW
CP-1D-175 175 1.17 DK. BLUE
CP-1D-250 250 1.4 YELLOW
CP-1D-340 340 1.13 RED
CP-1D-510 510 1.02 BLACK 029 25334 002
CP-1D-675 675 1.32 DK. PURPLE
CP-1D-900 900 1.02 DK. GREEN 029 25334 003
CP-1D-1200 1200 0.9 GRAY 029 25334 004
CP-1D-1360 1360 0.77 WHITE 029 25334 005
CP-1D-1785N 1785 0.88 GRAY/RED 029 25334 006
W D L B C T H
CP 3 5/8 7-3/4 6-1/2 4-3/4 1/2 5-5/8
C2P 3 5/8 10-1/2 9-1/4 7-3/4 9/16 6
MOUN
T
TYPE
DIMENSIONAL DATA (INCHES)
NOTES:
1. All dimensions are in inches per ANSI Y14.
2. Standard nish: Housing - Powder coated.
Spring - Powder coated. (Color: see Table)
Hardware - Zinc electroplate
3. Installation requires bolting or anchoring mount to support structure with a min. (2) 5/8" dia. bolt or (2) 1/2" dia. concrete anchors.
4. All springs are designed for 50 % over-travel.
5. Refer to next page for Installation Instructions.
Units shipped on or after June 15, 2008
MOUNT
TYPE
DIMENSION DATA (INCHES)
W D L B C T H
CP 3 5/8 7-3/4 6-1/2 4-3/4 1/2 5-5/8
C2P 3 5/8 10-1/2 9-1/4 7-3/4 9/16 6