Symbols and function of the rotation
cut-out when the attachment is not in
home position.
Requirements
– Attachment is not in the home position:
see page 192.
– A load greater than 500 kg is on the load
handler.
– Load handler is raised above 2 m.
Procedure
• Press the key (104) under the "warnings
sub-menu" symbol (172).
The display changes from the menu item
"warnings sub-menu“ (172) to the
symbols "rotation cut-out" (171) and "lift
cut-out" (161).
• The following hydraulic functions are
enabled and can be performed:
• Lowering the load handler, see
page 171.
• Attachment traverse, see page 177.
• The following hydraulic functions are
disabled and cannot be carried out:
• Fork carriage rotation.
• Lifting the load handler, see page 171.
Z
The "fork carriage rotation“ hydraulic function is released again when the load
handler has been lowered below 2 m.
The "lifting the load handler“ hydraulic function is released again when the load
handler is lowered below 2 mand the attachment is in the home position.
180
04.19 en-GB
To Next Page
Loading...
Need help?
General
