Juniper MX10003 - Connecting the MX10003 to the Network; Tools and Parts Required to Connect the MX10003 Router to External Devices; Connecting the MX10003 Router to External Devices and Cables

Prevention of Electrostatic Discharge Damage | 182
Connecting the MX10003 to the Network
IN THIS SECTION
Tools and Parts Required to Connect the MX10003 Router to External Devices | 100
Connecting the MX10003 Router to External Devices and Cables | 100
Tools and Parts Required to Connect the MX10003 Router to External
Devices
To connect the router to external devices, you need the following tools and parts:
•
2.5-mm flat-blade (–) screwdriver for the alarm relay contacts
•
Electrostatic discharge (ESD) grounding wrist strap (provided in the accessory kit)
SEE ALSO
Verifying the MX10003 Router Parts Received | 86
Prevention of Electrostatic Discharge Damage | 182
Connecting the MX10003 Router to External Devices and Cables
IN THIS SECTION
Connecting the Router to a Network for Out-of-Band Management | 101
Connecting the Router to a Console Device | 102
Connecting the Router to External Clocking and Timing Devices | 104
100