Figure 15: DC Power Cable Lug
CAUTION: Before router installation begins, a licensed electrician must attach a cable
lug to the grounding and power cables that you supply. A cable with an incorrectly
attached lug can damage the router.
DC Power Cable Specifications
You must supply four DC power cables that meet the following specifications: 10-AWG (1.3 mm
2
), minimum
60° C wire, or as required by the local code.
SEE ALSO
Routine Maintenance Procedures for MX10003 Routers | 116
Replacing an MX10003 DC Power Supply | 130
MX10003 Power Planning | 70
General Safety Guidelines and Warnings | 177
General Electrical Safety Guidelines and Warnings | 206
Prevention of Electrostatic Discharge Damage | 182
46
To Next Page
Loading...
