EasyManuals Logo

Juniper MX10003 Hardware Guide

Juniper MX10003
230 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #119 background imageLoading...
Page #119 background image
To install the air filter unit:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Ensure that the air filter unit is right side up.
3. Grasp the air filter unit and slide into the rails on the cable management brackets until it stops (see
Figure 35 on page 119). The air filter unit fits snugly on the cable management brackets.
Figure 35: Installing the Air Filter
4. Tighten the captive screws to secure the air filter unit.
SEE ALSO
MX10003 Cooling System Description | 31
Prevention of Electrostatic Discharge Damage | 182
Replacing the MX10003 Air Filter
IN THIS SECTION
Removing the MX10003 Air Filter | 120
Installing the MX10003 Air Filter | 121
119

Table of Contents

Other manuals for Juniper MX10003

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper MX10003 and is the answer not in the manual?

Juniper MX10003 Specifications

General IconGeneral
ModelMX10003
CategoryNetwork Router
Routing EngineRE-MX10003
Throughput2.4 Tbps
Operating SystemJunos OS
Power SupplyAC or DC
Rack Units/Form Factor3 U
RedundancyPower supplies, fans
Slot Count3

Related product manuals