Juniper MX10003 - Routing and Control Board Functions; Routing and Control Board Components; RCB Front Panel

CAUTION: If one of the RCBs fails, do not remove the failed RCB until you have a
replacement or blank panel to install.
The MX10003 router supports the following RCBs:
•
JNP10003-RE1
•
JNP10003-RE1-LT
This topic covers:
Routing and Control Board Functions
The Routing and Control Board integrates the Routing Engine and Control Board functions into a single
management unit. Each RCB provides all the functions needed to manage the operation of the modular
chassis:
•
System control functions such as environmental monitoring
•
Routing Layer 2 and Layer 3 protocols
•
Communication to all components such as line cards, power, and cooling
•
Transparent clocking
•
Alarm and logging functions
Routing and Control Board Components
Each RCB consists of the following internal components:
•
High-performance 1.6-GHz Intel 8 Core X86 CPU
•
64-GB DDR4 RAM
•
100-GB SATA SSD
RCB Front Panel
Figure 16 on page 49 shows the front panel of the MX10003 RCB (model number: JNP10003-RE1).
48