Juniper MX10003 - Connecting the MX10003 to Power; Tools and Parts Required for MX10003 Router Grounding and Power Connections

SEE ALSO
MX10003 Site Preparation Checklist | 59
General Safety Guidelines and Warnings | 177
General Electrical Safety Guidelines and Warnings | 206
Prevention of Electrostatic Discharge Damage | 182
Connecting the MX10003 to Power
IN THIS SECTION
Tools and Parts Required for MX10003 Router Grounding and Power Connections | 92
Grounding the MX10003 Router | 94
Connecting Power to an AC-Powered MX10003 Router | 95
Connecting Power to a DC-Powered MX10003 Router | 97
Tools and Parts Required for MX10003 Router Grounding and Power
Connections
To ground and provide power to the router, you need the following tools and parts:
•
Phillips (+) screwdrivers, numbers 1 and 2
•
Socket nutdriver
•
2.5-mm flat-blade (–) screwdriver
•
Torque-controlled driver, with a maximum torque capacity of 6 lb-in. (0.68 Nm), for tightening screws
to terminals on each power supply on a DC-powered router
92