CAUTION: The maximum torque rating of the terminal screws on the DC power
supply is 6 lb-in. (0.7 Nm). The terminal screws might be damaged if excessive torque
is applied. Use only a torque-controlled driver to tighten screws on the DC power
supply terminals. Use an appropriately sized driver, with a maximum torque capacity
of 6 lb-in. or less. Ensure that the driver is undamaged and properly calibrated and
that you have been trained in its use. You may want to use a driver that is designed
to prevent overtorque when the preset torque level is achieved.
•
Wire cutters
•
Electrostatic discharge (ESD) grounding wrist strap
SEE ALSO
MX10003 Router Grounding Specifications | 61
General Safety Guidelines and Warnings | 177
General Electrical Safety Guidelines and Warnings | 206
Prevention of Electrostatic Discharge Damage | 182
93
To Next Page
Loading...
