Juniper MX10003 - MX10003 Network Cable and Transceiver Planning; Calculating Power Budget and Power Margin for Fiber-Optic Cables

SEE ALSO
MX10003 AC Power System Description | 35
Routine Maintenance Procedures for MX10003 Routers | 116
Replacing an MX10003 AC Power Supply | 127
AC Power Cord Specifications for MX10003 Routers | 39
AC Power Circuit Breaker Requirements for the MX10003 Router | 38
General Safety Guidelines and Warnings | 177
General Electrical Safety Guidelines and Warnings | 206
Prevention of Electrostatic Discharge Damage | 182
MX10003 Network Cable and Transceiver Planning
IN THIS SECTION
Calculating Power Budget and Power Margin for Fiber-Optic Cables | 74
CB-RE and RCB Interface Cable and Wire Specifications for MX Series Routers | 77
Fiber-Optic Cable Signal Loss, Attenuation, and Dispersion | 78
Calculating Power Budget and Power Margin for Fiber-Optic Cables
Use the information in this topic and the specifications for your optical interface to calculate the power
budget and power margin for fiber-optic cables.
TIP: You can use the Hardware Compatibility Tool to find information about the pluggable
transceivers supported on your Juniper Networks device.
To calculate the power budget and power margin, perform the following tasks:
1.
How to Calculate Power Budget for Fiber-Optic Cable | 75
2.
How to Calculate Power Margin for Fiber-Optic Cable | 75
74