Juniper QFX Series - Console Port Connector Pinouts for the QFX Series

9. (Optional) Configure the static routes to remote prefixes with access to the
management port.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain
no-readvertise
10. Enable Telnet service.
[edit]
root@# set system services telnet
NOTE: When Telnet is enabled, you cannot log in to a QFX5110 switch
through Telnet using root credentials. Root login is allowed only for SSH
access.
11. Enable SSH service for root login.
[edit]
root@# set system services SSH
12. Commit the configuration to activate it on the switch.
[edit]
root@# commit
Related
Documentation
• Standalone Installation Overview on page 85
Copyright © 2019, Juniper Networks, Inc.106
QFX5110 Switch Hardware Guide