SCPI command subsystems reference tables
Tables 5-2 through 5-11 summarize the commands for each SCPI subsystem.
The following list includes the SCPI subsystem commands and the table
number where each command is summarized.
CALCulate command summary (Table 5-2)
DISPlay command summary (Table 5-3)
FORMat command summary (Table 5-4)
ROUTe command summary (Table 5-5)
SENSe command summary (Table 5-6)
STATus command summary (Table 5-7)
SYSTem command summary (Table 5-8)
TRACe command summary (Table 5-9)
Trigger command summary (Table 5-10)
UNIT command summary (Table 5-11)
General notes:
• Brackets ([ ]) are used to denote optional character sets. These optional
characters do not have to be included in the program message. Do not use
brackets in the program message.
• Angle brackets (< >) are used to indicate parameter type. Do not use angle
brackets in the program message.
• The Boolean parameter (<b>) is used to enable or disable an instrument
operation. 1 or ON enables the operation and 0 or OFF disables the oper-
ation.
• Upper case characters indicate the short-form version for each command
word.
• Default Parameter — Listed parameters are both the *RST and :SYS-
Tem:PRESet defaults, unless noted otherwise. Parameter notes are locat-
ed at the end of each table.
• SCPI — A checkmark (
√
) indicates that the command and its parameters
are SCPI confirmed. An unmarked command indicates that it is non-SC-
PI. SCPI confirmed commands that use one or more non-SCPI parameters
are explained by notes.
SCPI Command Reference 5-7
To Next Page
Loading...
Need help?
General
