Bus lines
The signal lines on the IEEE-488 bus are grouped into three different categories: data lines,
management lines and handshake lines. The data lines handle bus data and commands, while the
management and handshake lines ensure that proper data transfer and operation takes place.
Each bus line is active low, with approximately zero volts representing a logic 1 (true). The fol-
lowing paragraphs describe the operation of these lines.
Data lines
The IEEE-488 bus uses eight data lines that transfer data one byte at a time. DIO1 (Data In-
put/Output) through DIO8 (Data Input/Output) are the eight data lines used to transmit both data
and multiline commands and are bidirectional. The data lines operate with low true logic.
Bus management lines
The five bus management lines help to ensure proper interface control and management.
These lines are used to send the uniline commands.
ATN (Attention) — The ATN line is one of the more important management lines in that the
state of this line determines how information on the data bus is to be interpreted.
IFC (Interface Clear) — As the name implies, the IFC line controls clearing of instruments
from the bus.
REN (Remote Enable) —The REN line is used to place the instrument on the bus in the re-
mote mode.
EOI (End or Identify) — The EOI is usually used to mark the end of a multi-byte data transfer
sequence.
SRQ (Service Request) — This line is used by devices when they require service from the
controller.
E-6 IEEE-488 Bus Overview
To Next Page
Loading...
Need help?
General
