Keithley 2000 User Manual

SCPI Command Reference 5-61
:SYSTem subsystem
The SYSTem subsystem contains miscellaneous commands that are summa-
rized in Table 5-8.
:BEEPer command
[:STATe] <b>
:BEEPer[:STATe] <b> Enable or disable beeper
Parameters <b> = 1 or ON Enable beeper
0 or OFF Disable beeper
Query [:STATe]? Query state of beeper
Description This command is used to enable or disable the beeper for limit tests.
:PRESet command
:PRESet
:SYSTem:PRESet Return to :SYSTem:PRESet defaults
Description This command returns the instrument to states optimized for front panel op-
eration. :SYSTem:PRESet defaults are listed in the SCPI tables (Tables 5-2
through 5-11).
:KCLick command
:KCLick <b>
:SYSTem:KCLick <b> Enable or disable keyclick
Parameters <b> = 1 or ON Enable keyclick (default)
0 or OFF Disable keyclick
Query KCLick? Query status of keyclick
Description This command is used to enable or disable the keyclick. The keyclick can also be
enabled or disabled from the front panel by pressing SHIFT then LOCAL.

Keithley 2000 Specifications

General

Digits	6.5
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
Resistance Range	100 Ω to 100 MΩ
Connectivity	IEEE-488 (GPIB)
Display Type	VFD