SCPI Command Reference 5-71
:TRIGger commands
:COUNt <n>
:TRIGger[:SEQuence[1]]:COUNt <n> Set measure count
Parameters <n> = 1 to 9999 Specify count
INF Sets count to infinite
DEFault Sets count to 1
MINimum Sets count to 1
MAXimum Sets count to 9999
Query :COUNt? Queries programmed count
:COUNt? DEFault Queries *RST default count
:COUNt? MINimum Queries lowest allowable count
:COUNt? MAXimum Queries largest allowable count
Description This command is used to specify how many times operation loops around in
the trigger operation. For example, if the count is set to 10, operation con-
tinues to loop around until 10 device actions are performed. After the 10th
action, operation proceeds back up to the start of the trigger model. Note that
each loop places operation at the control source where it waits for the pro-
grammed event.
To Next Page
Loading...
