Keithley 2000 - Page 278

Specifications 1-3, A-1
Speed Commands 5-40
SPE, SPD (serial polling 4-17
Status byte and service request (SRQ) 4-25
Status byte register 4-26
Status messages 2-17, 4-18, B-1
Status structure 4-19
Status subsystem 5-52
Stepping trigger model additions 3-24
Storing readings 3-17
Storing readings in buffer C-6
System operations 3-32
T
Taking readings using the :READ? command C-
12
Taking readings with the scanner card C-8
Testing diodes 2-35
Thermal EMFs 2-20
Thermocouple commands 5-49
Threshold resistance level 2-34
Timing 3-28
Trigger level 2-26
Trigger model 3-8
Trigger model operation 4-30
Trigger model (GPIB operation) 4-29
Trigger operations 3-8
Trigger subsystem 5-70
Typical command sequences E-13
U
Unaddress commands E-10
Uniline commands E-9
Universal multiline commands E-9
Using common commands and SCPI commands
in the same messages 4-37
Using external scanner cards 3-22
Using OPEN and CLOSE keys 3-23
Using SHIFT-CONFIG to configure stepping
and scanning 3-26
V
Voltmeter complete 3-12
W
Warm-up time 2-16
Warranty information 1-3