Keithley 2000 - Page 8

Trigger model (GPIB operation) .......................................................4-29
Programming syntax .........................................................................4-32
Common commands..........................................................................4-39
5
SCPI Command Reference
SCPI Signal oriented measurement commands ..................................5-3
SCPI command subsystems reference tables ......................................5-7
Calculate subsystem..........................................................................5-20
DISPlay subsystem............................................................................5-26
:FORMat subsystem..........................................................................5-28
ROUTe subsystem.............................................................................5-32
[SENSe[1]] subsystem ......................................................................5-37
STATus subsystem.............................................................................5-52
:SYSTem subsystem..........................................................................5-61
:TRACe subsystem............................................................................5-68
Trigger subsystem .............................................................................5-70
:UNIT subsystem...............................................................................5-74
A
Specifications
Accuracy calculations.........................................................................A-7
Optimizing measurement accuracy..................................................A-10
Optimizing measurement speed .......................................................A-11
B
Status and Error Messages
C
Example Programs
Program examples.............................................................................. C-2
D
Models 196/199 and 8840A/8842A Commands
E IEEE-488 Bus Overview
Introduction.........................................................................................E-2
Bus description....................................................................................E-4
Bus lines..............................................................................................E-6
Bus commands ....................................................................................E-8
Interface function codes ....................................................................E-15
F
IEEE-488 and SCPI Conformance Information
Introduction.........................................................................................F-2