3-78 Keysight B1505A User’s Guide, Edition 12
Accessories
N1271A-005 Thermostream Compatible Enclosure for N1265A
(3kV IV, CV & 10kV)
The N1271A-005 is an enclosure to enable thermal testing by creating an interface
between the N1265A and an inTEST Thermostream. The enclosure supports fully
automated IV and CV measurements up to 3 kV, and IV measurements up to 10 kV
at temperature ranging from -50 °C to +220 °C. For the Thermostream, contact
inTEST Corporation.
This option includes the following components:
•Adapter
Adapter for connecting the enclosure to the test fixture. The output terminals
except for BiasTee, K Thermocouple, and UHV are connected to the enclosure.
• Pedestal
This supports the enclosure.
•Enclosure
A heat-resistant enclosure adapted with the interlock. Use this instead of the
fixture cover. The enclosure cover on the top surface is the docking interface
with the Thermostream.
The enclosure has cables for extending the Bias Tee High and Low terminals
and the UHV High and Low terminals. The ends of them in the enclosure have
M4 lug terminals for connecting DUT. You can change the lug terminals to other
size or type terminals if necessary. If you do not use them, clamp the cables in
the enclosure using clips.
• Test leads and connection kit for thermal test (N1254A-557)
• Six 20 cm small alligator clip - lug cables, six banana plugs, six nuts, and six
spare clips
• Two 20 cm large alligator clip - lug cables, two banana plugs, and two nuts
• Four 30 cm small alligator clip - lug cables, four banana plugs, four nuts, and
four spare clips
• Two 30 cm large alligator clip - lug cables, two banana plugs, and two nuts
To Next Page
Loading...
Need help?
General
