Keysight Technologies J-BERT M8020A User Manual

Keysight M8070A Programming Guide 157
SCPI Command Reference 5
URce]:JITTer:HFRequency:PERiodic(*):FREQuency[?]
Syntax [:SOURce]:JITTer:HFRequency:PERiodic(*):FREQuency ‘identifier’, <NRf>
[:SOURce]:JITTer:HFRequency:PERiodic(*):FREQuency? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataOut1' or 'M*.DataOut2', or 'M*.DataOut'
<NRf>: Set periodic jitter frequency.
Return Range 1 kHz to 500 MHz
Description This command sets the frequency of the periodic jitter for the specified
output.
The “(*)” suffix specifies which of the two periodic sources (1 or 2) for the
specified channel to use. If a suffix is not specified, the suffix 1 is assumed.
Acceptable units include Hz, kHz, MHz and exponents (for example, 1E3 is
the same as 1,000 Hz).
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8045A.
This SCPI is also available on M8195A for DataOut1 to 4.
Example :JITT:HFR:PER:FREQ ‘M1.DataOut2’, 20.0e6

Keysight Technologies J-BERT M8020A Specifications

General

Brand	Keysight Technologies
Model	J-BERT M8020A
Category	Control Unit
Language	English