Keysight M8070A Programming Guide 177
SCPI Command Reference 5
[:SOURce]:JITTer:SWEep[:STATe][?]
Syntax [:SOURce]:JITTer:SWEep[:STATe] ‘identifier’, <ON|OFF|1|0>
[:SOURce]:JITTer:SWEep[:STATe]? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataOut1' or 'M*.DataOut2'
<ON|OFF|1|0>: Enable/disable periodic jitter sweep.
Return Range 1|0
Description This command enables/disables the jitter sweep.
This SCPI is applicable for M8041A, M8051A and M8045A.
Example :JITT:SWE ‘M1.DataOut2’, on
[:SOURce]:JITTer:SWEep:FREQuency:STARt[?]
Syntax [:SOURce]:JITTer:SWEep:FREQuency:STARt ‘identifier’, <NRf>
[:SOURce]:JITTer:SWEep:FREQuency:STARt? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataOut1' or 'M*.DataOut2'
<NRf>: Set the start frequency.
Return Range 1 kHz to 500 MHz
Description This command defines the start frequency of the jitter sweep. The start
frequency must be lower than the stop frequency and the range should be
in accordance with the waveform. Acceptable units include Hz, kHz, MHz,
GHz and exponents (for example, 1E3 is the same as 1,000 Hz).
This SCPI is applicable for M8041A, M8051A and M8045A.
Example :JITT:SWE:FREQ:STAR ‘M1.DataOut2’, 500kHz
[:SOURce]:JITTer:SWEep:FREQuency:STOP[?]
Syntax [:SOURce]:JITTer:SWEep:FREQuency:STOP ‘identifier’, <NRf>
[:SOURce]:JITTer:SWEep:FREQuency:STOP? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataOut1' or 'M*.DataOut2'
<NRf>: Set the stop frequency.
Return Range 1 kHz to 500 MHz
To Next Page
Loading...
Need help?
General
