178 Keysight M8070A Programming Guide
5 SCPI Command Reference
Description This command defines the stop frequency of the jitter sweep. The stop
frequency must be higher than the start frequency and the range should
be in accordance with the waveform. Acceptable units include Hz, kHz,
MHz, GHz and exponents (for example, 1E3 is the same as 1,000 Hz).
This SCPI is applicable for M8041A, M8051A and M8045A.
Example :JITT:SWE:FREQ:STOP ‘M1.DataOut2’,500MHz
[:SOURce]:JITTer:SWEep:TIME[?]
Syntax [:SOURce]:JITTer:SWEep:TIME ‘identifier’, <NRf>
[:SOURce]:JITTer:SWEep:TIME? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataOut1' or 'M*.DataOut2'
<NRf>: Set duration of sweep.
Return Range 100 ms to 1.2 ks
Description This command defines the time duration of the jitter sweep. Acceptable
units include ms (milliseconds), s (seconds), ks (kiloseconds) and
exponents (for example, 1E3 is the same as 1,000 seconds).
This SCPI is applicable for M8041A, M8051A and M8045A.
Example :JITT:SWE:TIME ‘M1.DataOut2’, 100ms
[:SOURce]:JITTer:SWEep:STEP:[VALue][?]
Syntax [:SOURce]:JITTer:SWEep:STEP:[VALue] ‘identifier’, <NRf>
[:SOURce]:JITTer:SWEep:STEP:[VALue]? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataOut1' or 'M*.DataOut2'
<NRf>: Set number of steps for a complete sweep.
Return Range 2 to 100
Description This command defines the number of steps to fulfill a complete jitter
sweep.
This SCPI is applicable for M8041A, M8051A and M8045A.
Example :JITT:SWE:STEP ‘M1.DataOut2’, 50
To Next Page
Loading...
Need help?
General
