Keysight M8070A Programming Guide 179
SCPI Command Reference 5
[:SOURce]:JITTer:SWEep:STEP:DISTance[?]
Syntax [:SOURce]:JITTer:SWEep:STEP :DISTance ‘identifier’,
<EQUidistant|AUTOmatic>
[:SOURce]:JITTer:SWEep:STEP :DISTance? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataOut1' or 'M*.DataOut2'
<EQUidistan|AUTOmatic>: Specify log equidistant or frequency steps.
Return Range EQU|AUTO
Description The command defines whether the frequency steps are log equidistant
(EQUidistant) along the periodic jitter curve or a frequency step matches a
corner frequency on the jitter curve.
This SCPI is applicable for M8041A, M8051A and M8045A.
Example :JITT:SWE:STEP:DIST ‘M1.DataOut2’, AUTO
[:SOURce]:JITTer:SWEep:AMPLitude[:VALue]?
Syntax [:SOURce]:JITTer:SWEep:AMPLitude[:VALue] ‘identifier’, <NR3>
[:SOURce]:JITTer:SWEep:AMPLitude[:VALue]? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataOut1' or 'M*.DataOut2'
<NR3>: Specify constant jitter amplitude of the jitter sweep.
Return Range 0 mUI to 1.102 UI
Description This command sets the constant jitter amplitude of the jitter sweep. If
CONStant jitter amplitude is selected as the jitter sweep mode, this
command is used to define the value of the constant jitter amplitude of the
jitter sweep. Acceptable units include mUI, UI and exponents (for example,
100e-3 is the same as 100 mUI).
This SCPI is applicable for M8041A, M8051A and M8045A.
Example :JITT:SWE:AMPL ‘M1.DataOut2’, 1UI
[:SOURce]:JITTer:SWEep:AMPLitude:MODE[?]
Syntax [:SOURce]:JITTer:SWEep:AMPLitude:MODE ‘identifier’,
<CONStant|VARiable>
[:SOURce]:JITTer:SWEep:AMPLitude:MODE? ‘identifier’
To Next Page
Loading...
Need help?
General
