Keysight Technologies J-BERT M8020A User Manual

Keysight M8070A Programming Guide 199
SCPI Command Reference 5
[:SOURce]:INTerference:RANDom:HFRequency[?]
Syntax [:SOURce]:INTerference:RANDom:HFRequency ‘identifier’, <NRf>
[:SOURce]:INTerference:RANDom:HFRequency? ‘identifier’
Input
Parameters
‘identifier’: ‘M*.DATAOUT1’ or ‘M*.DataOut2’
<NRf>: Set random interference high frequency
Description This command sets the random interference high frequency in Hz.
This SCPI is applicable for M8195A and M8196A.
Example :INT:RAND:HFR ‘M2.DataOut1’, 1.0e9
[:SOURce]:INTerference:RANDom:LFRequency[?]
Syntax [:SOURce]:INTerference:RANDom:LFRequency ‘identifier’, <NRf>
[:SOURce]:INTerference:RANDom:LFRequency? ‘identifier’
Input
Parameters
‘identifier’: ‘M*.DATAOUT1’ or ‘M*.DataOut2’
<NRf>: Set random interference low frequency
Description This command sets the random interference low frequency in Hz.
This SCPI is applicable for M8195A and M8196A.
Example :INT:RAND:LFR ‘M2.DataOut1’, 1.0e9
[:SOURce]:INTerference:RANDom:CREStfactor[?]
Syntax [:SOURce]:INTerference:RANDom:CREStfactor ‘identifier’, <NRf>
[:SOURce]:INTerference:RANDom:CREStfactor? ‘identifier’
Input
Parameters
‘identifier’: ‘M*.DATAOUT1’ or ‘M*.DataOut2’
<NRf>: Set random interference crest factor value
Description This command sets the random interference crest factor value in dB or as
voltage ratio depending on the currently selected crest factor unit type.
This SCPI is applicable for M8195A and M8196A.
Example :INT:RAND:CRES ‘M2.DataOut1’, 12

Keysight Technologies J-BERT M8020A Specifications

General

Brand	Keysight Technologies
Model	J-BERT M8020A
Category	Control Unit
Language	English