Keysight M8070A Programming Guide 215
SCPI Command Reference 5
addressed by a register index of 0 up to 30. The values in the list specify
the register index and taps in the following order:
<RegNr><Pre2>,<Pre1>,<Post1>,<Post2>,< Post3>,< Post4>,< Post5>
Supported preset values for M8041A and M8051A are 0 - 30 and for
M8061A and M8062A, 0 is the only preset value.
This SCPI is applicable for M8041A, M8051A, M8061A and M8062A.
Example :OUTP:DEEM:PRES ‘M1.DataOut2’,2,1.1,2.2,4.3,6.7,5.3,6,3.3
:OUTPut:DEEMphasis:PRESet:ENABle[?]
Syntax :OUTPut:DEEMphasis:PRESet:ENABle ‘identifier’, <ON | OFF | 1 | 0>
:OUTPut:DEEMphasis:PRESet? ‘identifier’,
Input
Parameters
‘identifier’: 'M*.DataOut1' or 'M*.DataOut2'
<ON | OFF | 1 | 0>
Return Range <ON | OFF | 1 | 0>,
Description This command enables or disables changing the deemphasis preset
register number. Using this option, user can predefine separate set of
cursor values and can apply it using preset register number.
This query returns the present state.
This SCPI is applicable for M8041A, M8051A and M8062A.
Example :OUTP:DEEM:PRES:ENAB ‘M2.DataOut2’, ON
:OUTPut:DEEMphasis:SELect:PRESet[?]
Syntax :OUTPut:DEEMphasis:SELect:PRESet ‘identifier’, <NRf>
:OUTPut:DEEMphasis:SELect:PRESet? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataOut1' or 'M*.DataOut2'
<NRf>: Set current preset register.
Return Range 0 to 30
Description This command sets the current preset register. One in 31 registers can be
defined as the ‘current’ preset register. The tap values of the ‘current’
preset register are shown at the output. Preset register 0 is the default
To Next Page
Loading...
Need help?
General
