222 Keysight M8070A Programming Guide
5 SCPI Command Reference
:OUTPut:EINSertion[:STATe][?]
Syntax :OUTPut:EINSertion[:STATe] ‘identifier’, <ON|OFF|1|0>
:OUTPut:EINSertion[:STATe]? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataOut1', 'M*.DataOut2', or 'M*.DataOut'
<ON|OFF|1|0>: Switch error insertion output on or off.
Return Range 1|0
Description This command switches the error insertion feature on or off for the
specified output.
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8045A.
Example :OUTP:EINS ‘M1.DataOut1’, on
:OUTPut:EINSertion:RATio[?]
Syntax :OUTPut:EINSertion:RATio ‘identifier’, <RM1|...|RM12>
:OUTPut:EINSertion:RATio? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataOut1', 'M*.DataOut2', or 'M*.DataOut'
<RM1|...|RM12>: Set the error insertion ratio.
Return Range <RM1|...|RM12>
Description This command controls the ratio of the internal fixed error insertion ratio.
The range is 1E-12 (RM12) to 1E-1 (RM1).
This SCPI is applicable for M8041A, M8051A, M8061A, M8062A and
M8045A.
Example :OUTP:EINS:RAT ‘M1.DataOut1’, RM6
To Next Page
Loading...
