Keysight M8070A Programming Guide 221
SCPI Command Reference 5
:OUTPut:DEEMphasis:CURSor:MAIN:SUFFix?
Syntax :OUTPut:DEEMphasis:CURSor:MAIN:SUFFix? 'Identifier'
Input
Parameters
‘identifier’: 'M*.DataOut1' or 'M*.DataOut2'
Return Value 2
Description This query returns the main cursor’s suffix.
This SCPI is supported by M8045A.
Example :OUTP:DEEM:CURS:MAIN:SUFF? 'M1.DataOut1'
:OUTPut:EINSertion Subnode
This subnode has the following SCPI structure:
This subnode has the following commands:
Table 51
Name Description under
[:STATe][?] :OUTPut:EINSertion[:STATe][?] on page 222
:RATio[?] :OUTPut:EINSertion:RATio[?] on page 222
:MODE[?] :OUTPut:EINSertion:MODE[?] on page 223
:ONCE :OUTPut:EINSertion:ONCE on page 223
:DISParity :OUTPut:EINSertion:DISParity on page 224
To Next Page
Loading...
