Keysight Technologies J-BERT M8020A User Manual

Keysight M8070A Programming Guide 247
SCPI Command Reference 5
:INPut:CDR:LORDer[?]
Syntax :INPut:CDR:LORDer ‘identifier’, <FIRSt|SECond>
:INPut:CDR[:STATe]? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataIn1' or 'M*.DataIn2'
<FIRSt|SECond>: Set the loop order of the CDR.
Return Range FIRS|SEC
Description This command determines the loop order of the CDR. Depending on this
setting, defining the behavior of the CDR is done by different parameters.
For first order only, transition density and bandwidth fully define its
characteristics while for the second order this definition needs at least one
more parameter i.e. peaking.
This SCPI is applicable for M8041A and M8051A.
Example :INP:CDR:LORD ‘M1.DataIn1’, FIRS
:INPut:CDR:CTRL[?]
Syntax :INPut:CDR:CTRL ‘identifier’, <MANual|SEQuence>
:INPut:CDR:CTRL? ‘identifier’
Input
Parameters
‘identifier’: 'M*.DataIn1' or 'M*.DataIn2'
<MANual|SEQuence>: Set the CDR control method.
Return Range MAN|SEQ
Description This command selects whether the CDR is controlled manually or by the
sequencer.
This SCPI is applicable for M8041A and M8051A.
Example :INP:CDR:CTRL ‘M1.DataIn1’, SEQ

Keysight Technologies J-BERT M8020A Specifications

General

Brand	Keysight Technologies
Model	J-BERT M8020A
Category	Control Unit
Language	English